Aeon Labs Micro Smart Energy Illuminator Instrukcja Obsługi Pobierz pdf

AEO_MSEI

Micro Smart Energy Illuminator

Firmware Version : 1.24

Quick Start

A This device is a Z-Wave Actuator.

Single click the button located near the Status Indication LED or alternatively press quickly 6 times the external switch/button

control to include or exclude the device. If the Aeon Labs Micro Illuminator is not included into any Z-Wave network, the LED will

be blinking slowly continually.

Please refer to the chapters below for detailed information about all aspects of the products usage.

Product description

The Aeon Labs Micro Illuminator is a Z-Wave light dimmer specifically used to enable Z-Wave commands and control (on/off/dim)

for existing in-wall dimmers. Additionally the device can report wattage energy usage or kWh energy usage to a Z-Wave gateway

or controller. The wireless module is powered from the mains supply and is a three-wire design which requires a neutral

connection. In the event of power failure, non-volatile memory retains all programmed information relating to the units operating

status.

Installation Guidelines

The device is a 3 wire design which requires a neutral connection. The module is powered from the main supply.

The schematics below show how to wire the actuator. The power supply and the appliance are connected by the Load, Power Input

and Neutral connectors. The 3.3 Volt and External Switch connectors are for external switching.

After the electrical installation the device has to be implemented in the Z-Wave Network.

1 2 3 4 5

Brak uwag

Aeon Labs Micro Smart Energy Illuminator Instrukcja Obsługi